Search
Categories
new blog
Search
For the newest Firmware and UI, we push a new functions for our Tenlog IDEX 3D Printer, Print from Any Height! Download here, https://www.tenlog3d.com/download_d5 How to use? If any problem happen during printing, For example, a power outage, and your printer is an old version, don't support a power loss recovery, or yours are newest version support power loss recovery and just forget to click OK ...
Cura for Tenlog DMP 3D Printer, All the settings are built into the software, just download and use, no tedious settings. Download from our Software Center(Only Windows Available) https://www.tenlog3d.com/download_d5
Remember to level Nozzle Kit E1 Twice, to further reduce the deviation between the nozzle 1 and the hot bed!
1. Although we set the nozzle offset before leaving the factory, the machine structure may change during transportation, so after receiving the tenlog DMP 3D Printer, you should make an offset adjustment. This allows the Independent Dual Extruder 3D Printer to print a perfect Dual-Material object. 2. When you reset the tenlog DMP 3D Printer to factory settings, or any other time you find that ther...
We use TL-D3 Pro for demonstration. Just need to change building volume to other model, such as Hands 2 (220mm*220mm*250mm), TL-D5(500mm*500mm*500mm), TL-D6(600mm*600mm*600mm) 1. The most important thing is to set the Start and End G-code for the Tenlog DMP printer. So we first show the G-code settings in the machine settings. You can download all the pictures and G-code from our Download Center S...
1. Replace A4988 Driver to TMC2208 on motherboard 2. Download IDEX Firmware from our Download Center 3. Burn the TMC2208 Firmware
2
2
pagesCopyright © 2015-2024 Shenzhen Tenlog 3D Technology Co., Ltd.All Rights Reserved.